Content Preview

NEIEP REVIEW 1 2025 QUESTIONS AND ANSWERS A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do? - ....ANSWER ...-Replace it with a larger MOV On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue? - ....ANSWER ...-Suicide Circuit You have an old DC motor and are adding an SCR drive, what do you do to the interpoles? - ....ANSWER ...-Leave the interpoles alone. When adding a SCR drive to the generator, the series loop is removed, as are the 3 resistors. Everything else remains the same A hydro runs up with no load, but will not run with a full load. What is the issue? ....ANSWER ...-The relief valve is set too low Runby for a 1:1 hits the CWT buffer 4" below the top landing. CWT ruby should be set at 18". How much should the ropes be shortened? - ....ANSWER ...- 22" ....COPYRIGHT ©️ 2025 ALL RIGHTS RESERVED...TRUSTED & VERIFIED 1